Zigbee Network Communication Test; Unicast Test; Unicast Between The Terminal And The Coordinator With Short Addresses - Ebyte E180-DTU User Manual

Hide thumbs Also See for E180-DTU:

Table of Contents

Chengdu Ebyte Electronic Technology Co., Ltd

Similarly, routing nodes and terminal nodes also join a specific ZigBee network according to the above method. If the

node type is unchanged but needs to join to another ZigBee network, the Enter button

configuration also needs to be clicked. Modify the network parameters before write the parameters, finally restart, and

then join the new ZigBee network.

7.3 ZigBee network communication test

(1) Enter the configuration mode, configure the target network address, and change the target network address of the

coordinator to the local short address of the terminal (0xFCFA). The target network address of the terminal is 0 by

default, and 0 is the network short address of the coordinator (the network short address of the coordinator is always 0).

At this time, no modification is needed. If it communicates with a non-coordinator node, it needs to be modified

(modified it to the target Node's network local short address).

(2) After the target addresses between the nodes are configured, click "Enter Transmission Mode", and a message

box prompts "Enter transmission mode successfully ". Then confirm whether the module is in transmission mode before

communication, and they can only communicate in transmission mode. Input data in the sending area and click send, you

can see the received data in the message box of the terminal node.

hengdu Ebyte Electronic Technology Co.,Ltd

E180-DTU(ZG120-485) Usermanual

next to the node type

Table of Contents

Zg120-485