Fixture Installation - Elation KL PANEL XL User Manual

FIXTURE INSTALLATION

CLAMP INSTALLATION
A junior pin can be attached to the mounting surface on the fixture's mounting yoke, and this junior
pin can then be used as an attachment point for a mounting clamp. Details on junior pin installation
can be found in the Accessory Installation section of this manual.
The device also features a safety cable loop on mounting yoke hinge nearest to the DMX ports (see
the illustration below for reference). When mounting the fixture to a truss or any other suspended
or overhead installation, be sure to secure an appropriately rated clamp (not included) to the junior
pin and attach a separate SAFETY CABLE of the appropriate safety rating to the safety cable rig-
ging point. In the event that the optional barn doors are installed on this fixture, a secondary SAFETY
CABLE is also required to be attached to the barn doors, as shown in the image below. For informa-
tion on barn door installation, please refer to the Accessory Installation section of this manual.
ALWAYS ATTACH A SAFETY CABLE WHENEVER INSTALLING THIS FIXTURE IN A
SUSPENDED ENVIRONMENT TO ENSURE THAT THE FIXTURE WILL NOT FALL IF
THE CLAMP FAILS.
RIGGING
Overhead rigging requires extensive experience, including but not limited to: calculating working
load limits, understanding the installation material being used, and periodic safety inspection of all
installation material and the fixture itself. If you lack these qualifications, do not attempt to perform
the installation yourself. Improper installation can result in bodily injury.
11
AWAITING TRUSS
MOUNT PICS