Fixture Installation - Elation ACL PAR 200IP User Manual

F I X T U R E I N S T A L L A T I O N
C A U T I O N S
For added protection, mount the fixture in areas outside walking paths, seating
areas, or in areas were unauthorized personnel might reach the fixture.
Ambient operating temperature range for this fixture is
Do not use the fixture under or above this temperature.
Before mounting the fixture to any surface, make sure the installation area can
hold a minimum point load of 10 times the weight of the fixture.
Fixture installation must always be secured with a secondary safety attachment,
such as an appropriate safety cable.
Never stand directly below the device when mounting, removing or servicing.
Ensure ALL connections and end caps are properly sealed with a dielectric
grease (available at most electrical suppliers) to prevent water corrosion and/or
electrical short circuit.
POWER LINKING
Max number of units that can be power linked is 9 units @110V and 21 units @240V.
CLAMP MOUNTING
The fixture provides an integrated mounting dual bracket / yoke. Make sure to
secure an appropriately rated clamp to the mounting bracket using M10 screws
when mounting this fixture to truss.
F L A M M A B L E M A T E R I A L W A R N I N G
Keep fixture at least 5.0 ft (1.5m) away from any
flammable materials, decorations, pyrotechnics, etc.
E L E C T R I C A L C O N N E C T I O N S
A q u a l i f i e d e l e c t r i c i a n s h o u l d b e u s e d f o r a l l
e l e c t r i c a l c o n n e c t i o n s a n d / o r i n s t a l l a t i o n s .
w w w . e l a t i o n l i g h t i n g . c o m
5° to 113°F. (-15° to 45°C)
11
ACL PAR 200IP™ User Manual