Elation KL PANEL XL User Manual page 13

ACCESSORY INSTALLATION
STAND MOUNT INSTALLATION
This device is capable of being stand mounted by following the steps below:
1. Install the Junior Pin, as detailed elsewhere in this section.
2. Lock the mounting bracket in place by tightening both bracket knobs.
3. Insert the Junior Pin into the top of the Tripod Stand. Align the through-hole on the Junior Pin
with the holes in the top of the Tripod Stand, then insert the Locking Pin through the hole and
fasten in place.
4. If necessary, loosen the bracket knobs, adjust the fixture to the desired position, then tighten the
bracket knobs to lock the fixture in place. Use caution to prevent the Tripod Stand from tipping
over during adjustment.
See the picture below for reference:
13