SAFETY GUIDELINES
• DO NOT TOUCH the fixture housing during operation.
•
Turn OFF the power and allow approximately 15 minutes for the fixture to cool down before serving.
• DO NOT shake fixture and avoid brute force when installing and/or operating fixture.
• DO NOT operate fixture if the power cord is frayed, crimped, damaged, and/or if any of the power
cord connectors are damaged and do not insert into the fixture securely with ease.
• NEVER force a power cord connector into the fixture. If the power cord or any of its connectors are
damaged, replace it immediately with a new one of the same rating.
• DO NOT block any air ventilation slots.
•
All fan and air inlets must remain clean and never blocked.
•
Allow approx. 6" (15cm) between fixture and other devices or a wall for proper cooling.
•
When installing fixture in a suspended environment, always use mounting hardware that is no less
than M10 x 25 mm, and always install fixture with an appropriately rated safety cable.
•
Always disconnect fixture from main power source before performing any type of service and/or
cleaning procedure.
•
Only handle the power cord by the plug end, and never pull out the plug by tugging the wire portion
of the cord.
•
During the initial operation of this fixture, a light smoke or smell may emit from the interior of the fix-
ture. This is a normal process and is caused by excess paint in the interior of the casing burning off
from the heat associated with the lamp and will decrease gradually over time.
•
Consistent operational breaks will ensure fixture will function properly for many years.
• ONLY use the original packaging and materials to transport the fixture for service.
7