Specifications - Maktec MT816 Instruction Manual

ENGLISH (Original instructions)
1-1. Switch trigger
1-2. Lock button
2-1. Reversing switch lever
3-1. Action mode changing lever
4-1. Grip base
4-2. Teeth

SPECIFICATIONS

Capacities
No load speed (min
Blows per minute
• Due to our continuing program of research and development, the specifications herein are subject to change without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Intended use
The tool is intended for impact drilling in brick, concrete
and stone as well as for drilling without impact in wood,
metal, ceramic and plastic.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and
can only be operated on single-phase AC supply. They
are double-insulated and can, therefore, also be used
from sockets without earth wire.
Noise
The typical A-weighted
according to EN60745:
Sound pressure level (L
Sound power level (L
Uncertainty (K) : 3 dB(A)
Wear ear protection
Explanation of general view
4-3. Side grip (auxiliary handle)
4-4. Protrusion
4-5. Loosen
4-6. Tighten
5-1. Drill chuck
5-2. Chuck key
Model
Concrete
Wood
Steel
-1
)
Overall length
Net weight
Safety class
noise level determined
) : 90 dB(A)
pA
) : 101 dB(A)
WA
MT816
10 mm
18 mm
10 mm
0 - 2,800
0 - 30,800
242 mm
1.6 kg
ENE039-1
Vibration
The vibration
determined according to EN60745:
Work mode: impact drilling into concrete
ENF002-2
Vibration emission (a
Uncertainty (K) : 2.0 m/s
Work mode: drilling into metal
Vibration emission (a
Uncertainty (K) : 1.5 m/s
ENG905-1
The declared vibration emission value has been
•
measured in accordance with the standard test
method and may be used for comparing one tool
with another.
The declared vibration emission value may also be
•
used in a preliminary assessment of exposure.
WARNING:
The vibration emission during actual use of the
•
power tool can differ from the declared emission
value depending on the ways in which the tool is
used.
Be sure to identify safety measures to protect the
•
operator that are based on an estimation of
exposure in the actual conditions of use (taking
account of all parts of the operating cycle such as
the times when the tool is switched off and when it
is running idle in addition to the trigger time).
3
6-1. Sleeve
6-2. Ring
7-1. Side grip
7-2. Depth gauge
7-3. Grip base
7-4. Hex bolt
MT817/MT818
13 mm
18 mm
13 mm
0 - 2,800
0 - 30,800
255 mm/258 mm
1.8 kg/1.7 kg
/II
total value (tri-axial
) : 19.5 m/s
h,ID
2
2
) : 3.5 m/s
h,D
2
ENG900-1
vector sum)
2
ENG901-1