Installing A Psu Or Rps - HP Proliant ML150 G6 Maintenance And Service Manual

Installing a PSU or RPS

To install a PSU or RPS:
Tilting the power supply slightly, lower the unit into the chassis and slide over the support ledge
1.
to the rear of the chassis until it is flush against the rear panel.
Figure 3-438 Installing a PSU or RPS (RPS unit shown)
Secure the power supply to the rear chassis panel using the six mounting screws.
2.
Figure 3-449 Installing the rear mounting screws (RPS unit shown)
All manuals and user guides at all-guides.com
Removal and replacement procedures 70