Hdd Cage - HP Proliant ML150 G6 Maintenance And Service Manual

HDD cage

The server can accommodate two types of cages: a non-hot-plug HDD cage (without a backplane)
and a hot-plug HDD cage (with a backplane). In the standard configuration the server will have one
of these types of HDD cages installed in the upper hard drive area.
Removing and replacing a non-hot-plug HDD cage
The removal and replacement of the non-hot-plug HDD cage is described in the Hard Drive subsection
titled "Removing/replacing a non-hot-plug hard drive."
Removing and replacing a hot-plug HDD cage and backplane
To remove and replace the hot-plug HDD cage:
Power down the server.
1.
Disconnect the power cord(s).
2.
Remove the access panel and front bezel as described in the section titled "System covers."
3.
Remove all hard drives from the HDD cage as described in the section titled
4.
"Removing/replacing a hot-plug hard drive."
Disconnect the power data cables and 12C cable from the backplane of the HDD cage.
5.
Figure 3-15 Disconnecting cables from the HDD cage backplane
All manuals and user guides at all-guides.com
Removal and replacement procedures 40