HP Proliant ML150 G6 Maintenance And Service Manual page 37

All manuals and user guides at all-guides.com
To remove a hard drive from the HDD cage:
6.
Remove the four retaining screws (two on the top, two on the bottom) holding the drive in
a.
place (Figure 3-10, 1).
Slide the drive out from the HDD cage (Figure 3-10, 2).
b.
Figure 3-10 Removing a non-hot-plug hard drive
To replace a hard drive into the HDD cage:
7.
Slide the hard drive into the HDD cage (Figure 3-11, 1).
a.
Using the provided surplus screws if necessary (Figure 3-11, 2), install four retaining screws
b.
(Figure 3-11, 3).
Figure 3-11 Replacing a non-hot-plug hard drive
Re-install the non-hot-plug HDD cage into the server and re-install the six mounting screws.
8.
Connect the power and data cables to all hard drives.
9.
Replace the access panel and the front bezel.
10.
Reconnect the power cord(s).
11.
End of procedure.
To replace the non-hot-plug drive, reverse the steps 1 through 6.
Removal and replacement procedures 37