Table of Contents
Advertisement
Liquipoint FTW33
Factory setting
Operating hours
Navigation
Description
µC-temperature
Navigation
Description
Unit changeover (UNI) - µC-temperature
Navigation
Description
Switch on value
Options
Factory setting
Minimum µC-temperature
Navigation
Description
Maximum µC-temperature
Endress+Hauser
Output 1 (OU1): HNO
Output 2 (OU2): HNC
15.3.2
System
Parameter → System → Operating hours
This parameter counts the operating hours in minutes during the period in which operat-
ing voltage is present.
Parameter → System → µC-temperature
This parameter displays the current µC-temperature on the electronics.
Parameter → System → Unit changeover (UNI) - µC-temperature
This parameter is used to select the electronics temperature unit. Once a new electronics
temperature unit has been selected, the new unit is calculated and displayed.
Last unit selected prior to switching off.
• °C
• °F
• K
°C
Parameter → System → Minimum µC-temperature
This parameter is used as the minimum peak indicator and makes it possible to call up ret-
roactively the lowest electronics temperature measured.
If the value of the peak indicator is overwritten, the value is automatically set to the tem-
perature currently measured.
Description of Device Parameters
39
Advertisement
Table of Contents
