Table of Contents
Advertisement
Unpacking
This machine was carefully packaged for safe
transport. When unpacking, separate all enclosed
items from packaging materials and inspect them
for shipping damage. If items are damaged,
please call us immediately at (570) 546-9663.
IMPORTANT: Save all packaging materials until
you are completely satisfied with the machine and
have resolved any issues between Grizzly or the
shipping agent. You MUST have the original pack-
aging to file a freight claim. It is also extremely
helpful if you need to return your machine later.
Needed for Setup
The following items are needed, but not included,
for the setup/assembly of this machine.
Description
•
Additional Person for Lifting ....................... 1
•
Safety Glasses (for each person) ............... 1
•
Gloves .................................................1 Pair
•
Phillips Head Screwdriver #2 ..................... 1
•
Clean Shop Rags ....................... As Needed
•
Cleaner/Degreaser ..................... As Needed
•
Metal Lubricant ........................... As Needed
This machine is heavy. DO
NOT over-exert yourself
while unpacking or moving
machine—get assistance.
NOTICE
If you cannot find an item on this list, care-
fully check around/inside the machine and
packaging materials. Often, these items get
lost in packaging materials while unpack-
ing or they are pre-installed at the factory.
Model T32536 (Mfd. Since 10/20)
SECTION 3: SETUP
Qty
Inventory
The following is a list of items shipped with your
machine. Before beginning setup, lay these items
out and inventory them.
If any non-proprietary parts are missing (e.g. a
nut or a washer), we will gladly replace them; or
for the sake of expediency, replacements can be
obtained at your local hardware store.
Box 1 (Figure 5)
A. Lathe Assembly (not shown)
—Tool Rest Base (mounted) ...................... 1
—Tailstock (mounted) ................................. 1
B. Faceplate 5
⁄
" ............................................ 1
3
4
C. Tool Rest 4
⁄
" ............................................. 1
1
2
D. Tool Rest 7" ................................................ 1
E. Lock Levers ................................................ 2
F.
Knockout Tool ............................................. 1
G. Spur Center ................................................ 1
H. Live Center ................................................. 1
I.
Lock Handle M6-1 x 28 (Tool Rest) ............ 1
J.
Lock Handle M6-1 x 18 (Quill) .................... 1
K. Hex Wrenches 3, 5mm ..........................1 Ea
L. Open-End Wrench 19/27mm ...................... 1
M. Open-End Wrench 32mm .......................... 1
N. Open-End Offset Wrench 24.5mm ............. 1
B
C
F
G
K
L
Figure 5. Inventory components.
Qty
E
D
I
H
J
M
N
-13-
Advertisement
Table of Contents
