User Selection; Alternating Between 2 Users Or The Guest Mode; Data Memory; Viewing The Stored Values - Microlife BP W90 Manual

5. User Selection

This blood pressure monitor allows you to store the results for 2 indi-
vidual users. In addition, there is a guest mode, in which the results
are not stored.

Alternating between 2 users or the guest mode

1. While the unit is switched off keep the time button 6 pressed for
3 seconds until the user symbol AP or AQ starts to flash.
2. Press the M-button 5 to change between user 1, user 2 and the
guest mode.
3. Confirm the selection by pressing the start button 1.

6. Data Memory

At the end of each measurement, this device automatically stores the
result, including date and time.

Viewing the stored values

Press the M-button 5 briefly, when the device is switched off. The
display first shows «M» AL and then a value, e.g. «M 17». This
means that there are 17 values in the memory. The device then
switches to the last stored result.
Pressing the M-button again displays the previous value. Pressing
the M-button repeatedly enables you to move from one stored value
to another.
6
The user symbol AP or AQ indicates which user's memory is being
displayed. To change the user, please follow the instructions above.
 In the guest mode no memories are stored or displayed.

Memory full


Pay attention that the maximum memory capacity of 99 memo-
ries per user is not exceeded. When the 99 memory is full, the
oldest value is automatically overwritten with the 100th
value. Values should be evaluated by a doctor before the
memory capacity is reached – otherwise data will be lost.

Clearing all values of an individual user

The following procedure applies for the selected user (AP or AQ).
If you are sure that you want to permanently remove all stored
values, hold down the M-button (the device must have been switched
off beforehand) until «CL» appears and then release the button. To
permanently clear the memory, press the M-button while «CL» is
flashing. Individual values cannot be cleared.

How not to store a reading

As soon as the reading is displayed press and hold the ON/OFF
button 1 until «M» AL is flashing. Confirm to delete the reading by
pressing the M-button 5.