Advertisement
9
TROUBLESHOOTING
Trouble
Completely inactive
Sometimes inactive
Activated when no person
has passed
The alarm LED lights, but
connected units are inactive
10
SPECIFICATIONS
Model
PA-6612E
Detection system
Passive infrared
Wide angle
Coverage
40' (12m) Max.
Sensitive zone
17 pairs (64)
Supply voltage
10.5〜28V DC (non-polarity)
25mA Max.
Current consumption
（＋2mA at L/C use）
Dry contact (Semi-Conductor) (N.C. N.O. changeover)
Alarm signal
Reset : Approx. 2 sec., 24V(AC/DC) 0.25A
(protective resistance 3.3Ω)
3 minutes flashing, 47 minutes lighting and
Alarm memory
automatically reset
Red
Alarm LED
Yellow : Flashing at memory activated
Memory LED
Vertically 19.5° , Horizontally 25° (on mounting hole of base)
Adjustment
1 / 2 / 3 / 4 changeover
Count changeover
Slight movements of human beings can be detected
Fine motion detection
+5° F to +131° F (-15° C to +55° C) without condensation
Ambient temperature range
Indoor ceiling (wall mount with optional attachment BCW-401)
Mounting position
Terminals on separate base unit
Wiring connection
4.73oz (135g)
Weight
Thermo plastic resin
Appearance
Tapping screw : 2 pcs. Sensor locking screw : 1 pce.
Accessory
The specifications are subject to change without notice.
Limited Warranty :
TAKEX products are warranted to be free from defects in material and workmanship for 12 months from original date of shipment. Our warranty does not cover
damage or failure caused by natural disasters, abuse, misuse, abnormal usage, faulty installation, improper maintenance or any repairs other than those provided
by TAKEX. All implied warranties with respect to TAKEX, including implied warranties for merchantability and implied warranties for fitness, are limited in
duration to 12 months from original date of shipment. During the Warranty Period, TAKEX will repair or replace, at its sole option,free of charge, any defective
parts returned prepaid. Please provide the model number of the products, original date of shipment and nature of difficulty being experienced. There will be
charges rendered for product repairs made after our Warranty Period has expired.
In Japan
Takenaka Engineering Co., Ltd.
83-1, Gojo-sotokan, Higashino,
Yamashina-ku, Kyoto 607-8156, Japan
Tel : 81-75-501-6651
Fax : 81-75-593-3816
http : // www. takex-eng. co. jp /
Solve possible problems according to the following table.
restored by this means, contact either the dealer from whom you bought the unit or TAKEX.
Check
No power supply, broken wire or improper voltage.
Not yet 1 minute after power turned on (Alarm LED is flickering.)
Cover shielded by substances (including glass).
Improper area adjustment.
Improper area adjustment.
Cover face is soiled with dust or water drop.
Is the protection range proper ?
Unstable power voltage.
Something moving in protected area or too rapid temperature variations.
Large electrical noise source such as power machine nearby or
its wiring close to that of sensor.
Intense reflection of sun light or head light shining on the sensor.
Is the sensor reacting to passersby outside ?
Poor contact output connection or broken wire or short circuit.
Contact output is not working.
Is the connected unit operation nomal ?
: Flashing at warming up
Lighting at alarm (LED disabled)
Lighting at memory indication
In the U.S.
Takex America Inc.
151, San Zeno WAY
Sunnyvale, CA 94086, USA
Tel : 408-747-0100
Fax : 408-734-1100
http : // www. takex. com
Correct power supply or replace broken wire.
Allow for warming up time (about 1 min.)
Remove the substances.
Readjust the protection area setting.
Readjust the protection area setting.
Clean the cover with soft cloth.
(Do not use chemicals such as thinners or alcohol.)
Reposition so that the range is proper.
Stabilize the power voltage.
Remove the cause.
Relocate device.
Relocate device. Shield with a blind.
Readjust the protection area.
Check the wiring or connection.
Check the contact output terminal using a tester.
Check the connected unit.
11
EXTERNAL DIMENSIONS
φ4.72"(φ120mm)
▲
▲
φ3.88"(φ98.5mm)
Protection
In Australia
In the U.K.
Takex America Inc.
Takex Europe Ltd.
4/15 Howleys Road, Notting Hill,
Aviary Court, Wade Road,
VIC, 3168
Basingstoke, Hampshire. RG24 8PE, U.K.
Tel : +61 (03) 9544-2477
Tel : (+44) 01256-475555
Fax : +61 (03) 9543-2342
Fax : (+44) 01256-466268
http : // www. takex. com
If normal operations cannot be
Corrective Action
Base unit
φ3.29"(φ83.5mm)
2.63"(66.7mm)
▲
▲
Locking
screw hole
5-φ0.17"
(5-φ4.2mm)
Release lever
No.04-822
Sensor unit
R0.59"
(R15mm)
Wire hole
φ0.35"
(φ9mm)
1510
Advertisement
