Siemens LMV51 Series Basic Documentation page 118

4. Addressing the
actuators
Menu level 1 Menu level 2
Params & Display
Actuators
5. Selecting the actuator's
direction of rotation
Menu level 1 Menu level 2
Params & Display
Actuators
6. Activating and
deactivating the
auxiliary actuator
Menu level 1 Menu level 2
Params & Display
RatioControl
118/157
Siemens Building Technologies
HVAC Products
Prior to programming the actuators, the connector for the bus connection at the last
CAN bus element must be plugged in.
Menu level 3
Addressing
For addressing an actuator, select the respective type of actuator:
1. Air actuator
2. Gas actuator (oil) [for dual-fuel burners with only one fuel actuator]
3. Oil actuator
4. Auxiliary actuator
Confirm by pressing ENTER ( ® «Display and operating unit AZL51...»).
The AZL51... prompts you to operate the addressing switch on the actuator.
Menu level 3
DirectionRot
Select the direction of rotation with Standard or Reversed.
The standard direction of rotation is anticlockwise when facing the end of the drive shaft
( ® «Display and operating unit AZL51...»).
Note: After setting the ignition positions / curves, the direction of rotation can only be
changed after canceling the curves and the ignition positions on the setting
menu «DeleteCurves».
Depending on the application and the type of fuel (with or without auxiliary actuator), the
auxiliary actuator can be activated or deactivated.
Menu level 3
GasSettings
OilSettings
Basic Documentation LMV51...
7 Commissioning instructions for the LMV51... system
Menu level 4 Menu level 5
1. AirActuator
2. GasActuat.(Oil)
3. OilActuator
4. AuxActuator
Menu level 4 Menu level 5
DeleteCurves
1. AirActuator
2. GasActuat.(Oil)
3. OilActuator
4. AuxActuator
Menu level 4 Menu level 5
AuxActuator
AuxActuator
Menu level 6
Menu level 6
Menu level 6
CC1P7550en
29.05.2002