ADA INSTRUMENTS DigiTeo-2 Operating Manual page 12

Operating
6. Collimate the first
target A, through the
under plate level fix
screw and the jiggle
screw.
7. Press [OSET] ,
and make the first
target horizontal angle
0°00'00".
8. Collimate the first
target B, through the
under plate level fix
screw and the jiggle
screw.
9. Press [HOLD], it
will display the
average.
Display
12
DigiTeo-2/5/10/20
Operating
10. Repeat 2-8,
you can get the
measure you need.
● In the repeat measure mode, the times should in nine times,
if it is over the times, the display is error..
● In the repeat measure mode, the measure error is ≥30",
If the instrument display error information. You must do
from 2.
● Press [SFT], exit from this mode
MEASUREMENT FOUNDATION
Display