Zennio WinDoor RF Quick Start Manual page 9

Alarm:
(Status)" through which a '1' is sent when the device enclosure is removed.
Note: the tamper alarm will be sent 5 times after each change of state or reset.
Alarm:
(Status)" through which a '1' is sent when the battery level is about to run out.
Whenever this parameter is enabled, Heartbeat will necessarily be enabled.
Important: For a correct measurement of the battery status it is necessary
to link the Heartbeat object so that it will be sent periodically. Because of
this, whenever the battery alarm is enabled, the Heartbeat will also be forced
to be enabled.
Note: the battery alarm will be sent twice after each change of state or reset.
https://www.zennio.com
Tamper [enabled/disabled]: enables the object "Alarm: Tamper
Battery [enabled/disabled]: enables the object "Alarm: Battery
WinDoor RF / WinDoor RF 915
Technical Support: https://support.zennio.com
9