Table of Contents
Advertisement
From this screen, configurating the next parameters will be possible:
Transmission Power [Minimum / Low /
to set the transmission power of the device.
Note: higher transmission power increases the transmission distance of the
WinDoor RF but also shortens battery life.
Heartbeat (Periodic Alive Notification) [enabled/disabled]: incorporates a
one-bit object to the project ("[Heartbeat] Object to Send '1'") that will be sent
periodically with a value of "1" to notify that the device is still working (still alive).
Note: the first sending after download or bus failure takes place with a delay of
up to 255 seconds, to prevent bus overload. The following sendings match the
period set.
Window/Door Status Object [enabled]: enables the object "Window/Door
(Status)" though which the notification of the window/door status is sent. After
each state change, this object is always sent twice to ensure a correct
communication. Associated with this functionality, the following parameters are
shown:
➢ Object Polarity [0 = Open; 1 = Closed /
polarity of the object "Window/Door (Status)".
➢ Delay [0...255][s]: allows to set a delay in seconds from detecting a change
in the window/door status until the value is sent.
➢ Periodic Send (0 = Disabled) [0...24][h]: allows to configure a periodic
sending in hours of the window/door status.
1
The default values of each parameter will be highlighted in blue in this document, as follows:
[default/rest of options].
https://www.zennio.com
Medium
Figure 3. Heartbeat
0 = Closed; 1 =
Technical Support:
WinDoor RF / WinDoor RF 915
1
/ High / Maximum]
: allows
Open]: sets the
https://support.zennio.com
8
Advertisement
Table of Contents
