Function Buttons - Husqvarna Viking Designer Topaz 25 User Manual

FUNCTION BUTTONS

1
7
8
9
1.
Press this button to start or stop the machine sewing or
embroidering when you are not using the foot control. Press
Your machine stops automatically at color changes and when
2. STOP (MONOCHROME)
IN SEWING MODE:
thread and stops automatically when one stitch unit or stitch
the stitch is completed. Press the button again if you wish to
the same size.
Tip: If you want to repeat the STOP function for a stitch unit several
times in a row you can save the stitch with a STOP at the end in a
program (see programming, page 40).
IN EMBROIDERY MODE:
3. FIX (BASTE)
FIX is used to tie off a stitch. FIX is
IN SEWING MODE:
and continues with the selected stitch. Press FIX while sewing
and your machine sews a few tie-off stitches and stops
function can be programmed, see page 40.
26
2 3 4 5 6
Note: FIX Auto can be cancelled in the SET Menu (see page 31). No
automatic FIX stitches will be sewn unless you use the FIX button on
your machine.
Press FIX to baste an outline of the
IN EMBROIDERY MODE:
embroidery design area or to baste the fabric to the stabilizer.
4. SELECTIVE THREAD CUTTER
IN SEWING MODE:
and your machine ties off the threads, cuts the top and bobbin
FIX function for the next start. To cut threads at the end of
sewing.
When the stitch or stitch program is
completed, the machine willl make a FIX and then cut the
function can be programmed, see page 40.
Note: Your machine cuts the threads automatically after certain stitches
such as completing a Sensor One Step Buttonhole. Selective Thread
Cutter Auto can be cancelled in the SET Menu, see page 31.
IN EMBROIDERY MODE:
Cutter while embroidering it automatically cuts the top and
color block only the top thread is cut. When the design is
Note: Selective Thread Cutter Auto can be cancelled in the SET Menu,
see page 31.
5.
IN SEWING MODE:
the needle up or down. The setting of the needle stop position
is changed at the same time.
You can also tap the foot control to raise or lower the needle.
If both the needle and the presser foot are in up position, only
the presser foot will be lowered when you tap the foot control
ly.
TRIM POSITION)