Chapter 3 Configuring Intel Pmem 200 Series Using Bios - Supermicro Optane Persistent Memory 200 Series User Manual

Super Intel® Optane™Persistent Memory 200 Series Configuration User's Guide
Configuring Intel PMem 200 Series Using BIOS
This chapter provides an illustration on how to configure Intel PMem 200 Series settings on
the X12 motherboards using the BIOS Setup utility.
Important Notes to the User
The procedures shown below are based on the following motherboard and memory
configuration:
•
Motherboard used: X12DxxU-6 (The X12DxxU-6 with 32 DIMM modules installed.)
•
Memory populated : 8x 16GB DDR4 2666MHz RDIMM on 8x blue DIMM slots of CPU1
socket, and 8x 256GB PMem DCPMM-DIMM on 8x black DIMM slots of CPU1 socket
•
Memory population is based on the Memory Population Table below. For more information
on memory population, please refer to the Memory Configuration User Guide for the X12
Motherboards posted on our wetsite at https://www.supermicro.com/support/manuals/.
•
Only App Direct Mode and Memory Mode are supported for the X12 motherboards.
PMem 200 Series Population Table for X12Dxx 32-DIMM Motherboards (within 1 CPU socket)
DDR4+ AD Inter- P1- P1-
Mode
PMem leave DIMMF1 DIMMF2
8+8 AD, MM One - x8 DDR4 PMem
Note: Please make sure that all x8 DDR4 DIMMs and x8 PMem DCPMM DIMMs are
detected prior to PMem 200 Series configuration as shown below: (under BIOS/Ad-
vanced/Chipset Configuration/North Bridge/Memory Configuration/Memory Topology).
Chapter 3
P1- P1- P1- P1- P1-
DIMME1 DIMME2 DIMMH1 DIMMH2 DIMMG1
DDR4 PMem DDR4 PMem DDR4
22
P1- P1- P1- P1- P1-
DIMMG2 DIMMC2 DIMMC1 DIMMD2 DIMMD1
PMem PMem DDR4 PMem DDR4
P1- P1- P1- P1-
DIMMA2 DIMMA1 DIMMB2 DIMMB1
PMem DDR4 PMem DDR4