Table of Contents
Advertisement
Installation
Flange Connections
The fluid inlet and outlet ports are 2 in. raised face, standard
150 lb class pipe flanges. Connect 2 in. flanged plastic pipe
to the pump as follows. You will need:
•
torque wrench
•
adjustable wrench
•
a 6 in. diameter, 1/8 in. thick PTFE gasket, with four 0.75 in.
diameter holes on a 4.75 in. diameter bolt circle, and a
2.20 in. diameter center
•
four 5/8 in. x 3 in. bolts
•
four 5/8 in. spring lockwashers
•
eight 5/8 in. flat washers
•
four 5/8 in. nuts.
BOLT TIGHTENING SEQUENCE
_______________________________________________________________________
F
. 3
IG
10
819.4496
1
F
D
E
1.
Place a flat washer (E) on each bolt (C). Refer to F
2.
Align the holes in the gasket (B) and the pipe flange (A)
with the holes in the pump outlet flange (S).
3.
Lubricate the threads of the four bolts. Install the bolts
through the holes and secure with the washers (E),
lockwashers (D), and nuts (F).
4.
Hold the nuts with a wrench. Refer to the tightening
sequence in F
. 3 and torque the bolts to 27–41 N•m.
IG
Do not over-torque.
5.
Repeat for the pump inlet flange (R).
3
S
2
B
A
R
KEY
A
Flanged Plastic Pipe
B
PTFE Gasket
C
Bolt
D
Lockwasher
E
Flat Washer
F
Nut
R
2 in. Fluid Inlet Flange
S
2 in. Fluid Outlet Flange
1
Lubricate threads. Torque to 27–41 N•m. Do
not over-torque.
. 3.
IG
1
4
04405
E
C
1
04615B
Advertisement
Table of Contents
