Non-Host-Adapter Specific; Host-Adapter Specific - Dell 4100 User Manual

Specific error codes appear only if you have installed the
host adapters and drivers that generate them.
Non–Host-Adapter Specific
000 Failed ParseDriverParameters call
A call to NetWare's ParseDriverParameters routine has
failed for some unknown reason. The command line con-
tains errors, or you pressed <
prompt.
001 Unable to reserve hardware, possible
conflict
The driver failed in its attempt to reserve the host
adapter's hardware settings (that is, direct memory access
[DMA] and interrupt request [IRQ] settings). Another
card in your system may be causing a conflict with the
host adapter.
002 NetWare rejected card Failed AddDisk-
System call
The driver failed in its attempt to register the host adapter
with NetWare. The file server may not have enough
memory.
003 Invalid command line option entered >
option
An invalid option was entered on the command line. The
invalid option that was entered is also displayed.
004 Invalid command line, please enter
correctly
The driver was unable to understand the command line
options you entered. Be sure you have entered these
options correctly.
3-20 Dell PowerEdge 4100/180 and 4100/200 Systems User's Guide
> at the port or slot
ESC

Host-Adapter Specific

200 No host adapter found for this driver
to register
No Adaptec 78xx host adapter was found in your com-
puter for the driver to register. Be sure the host adapter is
properly configured and properly seated in the slot.
203 Invalid 'device' setting
You have entered an invalid slot setting on the command
line. You can only enter slot numbers for valid host
adapters. If you load without the slot option, you will be
prompted to enter a valid value.
204 Invalid 'verbose' setting, use 'y'
You can only enter y for this option (verbose = y).
205 Invalid 'removable' setting, use 'off'
You can only enter off for this option (removable =
off).
206 Invalid 'fixed_disk' setting, use 'off'
You can only enter off for this option (fixed_disk =
off).
208 SCSI present but not enabled/configured
for PCI
A host adapter is present, but its bus or device entry has
not been enabled.