Exiting Scsiselect; Installation For Microsoft Windows Nt; Installation Overview; Installing Windows Nt 3.51 And The Driver - Dell 4100 User Manual

When you select a specific ID and device, a small menu
appears, displaying the
FORMAT DISK
options.
MEDIA
•
. This option runs a utility that allows
FORMAT DISK
you to perform a low-level format on a hard-disk
drive. Most SCSI disk drives are formatted at the
factory and do not need to be formatted again. The
Adaptec Format Disk utility is compatible with the
vast majority of SCSI disk drives.
.
CAUTION: The
all data on the hard-disk drive.
•
. This option runs a utility that
VERIFY DISK MEDIA
allows you to scan the media of a hard-disk drive for
defects. If the utility finds bad blocks on the media, it
prompts you to reassign them; if you select
those blocks are no longer used. You can press
< > at any time to exit the utility.
ESC

Exiting SCSISelect

To exit SCSISelect, press <
you to exit. (If you changed any 78xx series host adapter
settings, you are prompted to save the changes before you
exit.) At the prompt, select
any key to reboot the computer. Any changes you made
in SCSISelect take effect after the computer boots. (You
can select at the prompt if you are not ready to exit
NO
SCSISelect.)
I
nstallation for Microsoft Win-
dows NT
Read this section to find out about Windows NT operat-
ing system installation, including:
•
Installing and/or updating the SCSI drivers for the
Windows NT operating system
•
Removing a host adapter
•
Swapping a host adapter
•
Restoring a configuration if Windows NT fails to
boot
3-6 Dell PowerEdge 4100/180 and 4100/200 Systems User's Guide
and
VERIFY DISK
option destroys
FORMAT DISK
YES
> until a message prompts
ESC
to exit, and then press
YES

Installation Overview

This section provides the information needed to install
and use the Dell SCSI drivers for the 78xx series of SCSI
controllers with the Windows NT operating system.
The Windows NT 3.51 driver diskette you create for the
Microsoft Windows NT Server 3.51 operating system
contains the files needed for driver installation. The \scsi
subdirectory on the diskette contains the following files
to be used with Windows NT 3.51:
•
aic78xx.sys — Adaptec's 78xx Family driver for
Windows NT
•
oemsetup.inf — A file used by Windows NT Setup
for driver installation
•
readme.txt — A text file describing the Adaptec
78xx driver for Windows NT
,
If you are performing a first-time Windows NT
installation, see the following subsection, "Installing
Windows NT 3.51 and the Driver," to begin driver
installation. If Windows NT is already installed in your
system, see "Using Windows NT to Install or Update the
Driver" found later in this section.
Installing Windows NT 3.51 and the
Driver
This section describes how to install the aic78xx.sys
driver at the same time you install Windows NT 3.51. If
Windows NT 3.51 is already installed and you wish to
install or update the aic78xx.sys driver, see "Using Win-
dows NT to Install or Update the Driver," found later in
this section.

Performing a Windows NT 3.51 Installation

Follow these instructions only if you are installing
Windows NT 3.51 for the first time. You can install
Windows NT 3.51 from a diskette drive or from a
CD-ROM drive; whichever you choose, make sure the
hardware installation is completed prior to following
these steps.
NOTE: An older version of the aic78xx.sys driver is
included in the Windows NT installation diskettes (or on
the CD-ROM). To avoid loading the older driver during
Windows NT installation, use the following procedure to