Table 3-1. Default Scsi Controller Settings - Dell 4100 User Manual

NOTES: The SCSISelect Utility must be run for both the
AIC-7880 and AIC-7860 SCSI controllers if you need to
change the configuration settings.
The term host adapter is used throughout this chapter to
refer to the built-in AIC-7880 and AIC-7860 SCSI con-
trollers or the optional AHA-2940 SCSI controller card.
For situations in which you might want or need to change
the settings, see the descriptions of each setting in the fol-
lowing subsections. To change any of the default settings
or to format or verify a disk, see "Starting the SCSISelect
Utility" found later in this chapter.
3-2 Dell PowerEdge 4100/180 and 4100/200 Systems User's Guide

Table 3-1. Default SCSI Controller Settings

Setting
SCSI Bus Interface Definitions:
HOST ADAPTER SCSI ID
SCSI PARITY CHECKING
HOST ADAPTER SCSI
TERMINATION
Boot Device Options:
BOOT TARGET ID
BOOT LUN NUMBER
SCSI Device/Configuration:
INITIATE SYNC NEGOTIATION
MAXIMUM SYNC TRANSFER RATE
ENABLE DISCONNECTION
INITIATE WIDE NEGOTIATION
SEND START UNIT COMMAND
Advanced Host Adapter:
HOST ADAPTER BIOS
SUPPORT REMOVABLE DISKS
UNDER BIOS AS FIXED DISKS
EXTENDED BIOS TRANSLATION
>
FOR DOS DRIVERS 1 GB
< >< >
DISPLAY CTRL A MESSAGE
DURING BIOS INITIALIZATION
MULTIPLE LUN SUPPORT
BIOS SUPPORT FOR BOOTABLE
CD-ROM
BIOS SUPPORT FOR INT 13
EXTENSIONS
SUPPORT FOR ULTRA SCSI
SPEED
NOTE: For the full name of an abbreviation or acronym
used in this table, see the Glossary.
Default
7
ENABLED
LOW ON/HIGH
ON
0
0
YES (ENABLED)
40 MB/SEC
YES (ENABLED)
YES (ENABLED)
YES (ENABLED)
ENABLED
BOOT ONLY
ENABLED
ENABLED
DISABLED
ENABLED
ENABLED
ENABLED