Mounting The Front Panel - Hanseatic HGTI6082C13K7709DS User Manual

Page EN-32 Installation, connection and initial use

Mounting the front panel

You can mount a front panel on the dishwash-
er which matches your kitchen. The front pan-
el must not exceed a weight of 5 kg.
1. Hold the front panel against the dish-
washer door such that the lower side of
the front panel is flush with the adjoining
kitchen cupboards.
2. Measure the distance between the front
panel and the control panel.
(g)
3. A gap of 5 mm to 25 mm can be offset
with the 5 trim strips supplied (g). Remove
the required number of trim strip from the
block. To do so, move the trim strip vigor-
ously but without using tools.
4. If you only need one trim strip,
saw off the four feet that stick
out, clamp the trim strip
under the control panel and
secure it using both counter-
sunk screws (l).
Continue with Step 7.
5. If you need more than one trim strip,
turn the lower trim strip and push it onto
the other trim strips. This hides the feet
and makes the surfaces flat.
6. If you
– need two trim strips, secure these using
both countersunk screws (l).
– need three trim strips, secure these
using both countersunk screws (m).
– need four to five trim strips, secure these
using both countersunk screws (n).
(h)
7. Pull apart the two pairs of Velcro
straps (h).
8. Remove the protective film from the same
type of Velcro strap.
9. With the protective film removed,
stick the Velcro straps (h) to the middle
of the recessed areas on the dishwasher
door.
10. Cut the positions of the Velcro straps out
of the drilling template.
11. Cut the number of trim strips used off the
drilling template.
(h)
(h)