Error Message In The Display - Hanseatic HGTI6082C13K7709DS User Manual

Page EN-36 Troubleshooting table
Problem Possible cause
The dishwasher salt is
The display
clumpy.
(13) is illuminated
although dishwash-
er salt has been
added.
The water is not There is a kink in the inlet
running or it is hose.
running only very
The water tap is not on
slowly.
properly.
The water is not The filters are blocked.
running off or only
The outlet hose is kinked,
very slowly.
has been extended or is
hanging too high up/too low.
The dishwasher is The door seal is defective.
not watertight.
The outlet hose or the inlet
hose is defective.
The dishwasher The dishwasher can only be
can be switched operated when the door is
on/off, but not can- closed.
not be operated.

Error message in the display

Code Solution
: Turn the water tap on completely.
E1
It takes too long for
Lay out the inlet hose in such a manner that it is not kinked.
the water to fill up.
See „Connecting the inlet hose" on page EN-29.
Ensure that the water pressure is correct. See „Technical specifications"
on page EN-40.
: Switch off the tap. Find the gap in the seal (or have someone find it) and
E4
Water overflow repair the leak (or have it repaired).
:
E8
Have the appliance examined and repaired.
Internal fault
:
Ec
Fault in the wash- Have the appliance examined and repaired.
ing control system
Solution
Stir the dishwasher salt using the end of a
spoon or similar.
Lay out the inlet hose in such a manner
that it is not kinked.
Turn the water tap on completely.
Clean the filters (see page EN-26).
Lay out the outlet hose in the proper manner
(see page EN-29).
Have the door seal replaced (see „Service"
on page EN-38).
Have the defective hose replaced
(see „Service" on page EN-38).
Close the door.