Electrical Connections; Installation - Hanseatic HGTI6082C13K7709DS User Manual

Page EN-30 Installation, connection and initial use
For water supply, you need a water tap with
a ¾ inch screw connector.
1. Screw the safety valve's lock nut to the
tap hand-tight.
2. Check that the connection to the water
tap is sealed. Turn on the water tap slowly
and ensure that no water is escaping.
3. Then close the tap again.

Electrical connections

WARNING!
Electric shock / fi re hazard!
■ Prior to connecting the dishwasher,
ensure that you have page EN-5 tak-
en note of all the safety instructions
and adhered to them.
Depending on the recess into which the dish-
washer will be fitted, the dishwasher should
be connected before or after fitting.
– For the electrical connection of the dish-
washer, a professional must install an
earthed power socket with its own fuse of
a sufficient size (230 V~/50 Hz/10 A).
– The plug must be installed in such a way
that the recess into which the dishwasher
will be fitted is deep enough even when the
plug is plugged in.
– Do not use a multi-socket extension cable,
multi-socket plug, travel adapter, extension
cable or similar.
– We recommend using a pulse-sensitive re-
sidual current device (RCD).
• Insert the mains plug into the socket.

Installation

NOTICE
Risk of damage!
Selecting the wrong screws can dam-
age the worktop.
■ Use the screws which are supplied in
the delivery or screws of an appropri-
ate length.
1. Disconnect the power supply at the fuse
box.
2. Remove cardboard, polystyrene and ad-
hesive strips from the inside of the dish-
washer, if you have not already done so.
(d)
3. Affix the condensation protection film
supplied (d) to the underside of the work-
top. In this way, you will avoid damage to
the work surface as a result of hot steam
which may be emitted from the dishwash-
er if the dishwasher door is left open.
(e)
4. Insert the two mounting brackets (e) into
the front slots on the top of the
dishwasher so that you can screw the
dishwasher to the worktop subsequently.