１０．Specifications; General Specifications - Melec ADB-2F45U Instruction Manual

１０．Specifications
１０－１．General Specifications
Supply Power
Motor output
current
Input Signal
Output Signal
Functions of
Operating Sections
Operating Ambient
Temperature
Operating Ambient
Humidity
Storing Temperature
Storing Humidity
Atmosphere
Withstanding
Vibration
Insulation resistance
Exterior Dimensions
Weight
Input voltage range is DC+24V±10%.
*1
Use a power supply that provides sufficient input current.
*2
DC+24V
*1 (Ripple voltage P-P 2.0V or less)
● Rated input current :
at DRIVE
● Rated input current :
at HOLD
●DRIVE CURRENT 0.50A/phase～2.00A/phase
●HOLD CURRENT Approx. 40% of DRIVE CURRENT
(factory-set)
●Drive pulse input
●Motor excitation stop input (M.F)
●Phase signal output
●Overheat alarm output
●HOLD CURRENT selection
●DRIVE CURRENT selection
●STEP TABLE selection
●STEP ANGLE selection
●HOLD SWITCHING TIME selection
●PULSE INPUT TYPE selection
0℃ ～ +40℃ (No freezing allowed.)
80％RH or less (No condensation allowed.)
-10℃ ～ +55℃ (No freezing allowed.)
80％RH or less (No condensation allowed.)
Indoor (Exposure to direct sun is not allowed.)
Without any explosive, corrosive or inflammable gas, oil mist,
or dust.
No abnormality should be found after a vibration test
DC connector - signal connector - Frame
(Each other)
Ｈ Ｗ Ｄ
75 × 58 × 32 (mm)
0.11 kg
-29-
〔DRIVE I.SEL ⇒ No.F set up〕
DC+24V: 2.5A
〔HOLD I.SEL ⇒ Approx. 40％ set up〕
DC+24V: 0.6A
(CW, CCW)
(P.O)
(O.H.A)
(HOLD I.SEL)
(DRIVE I.SEL)
(S.T SEL)
(STEP SEL)
(DHT SEL)
(SPI SEL)
at 10～55Hz, 0.15mm P-P
DC500V 100MΩ or more
ADB-2F45U
Instructions Manual
*2
Photo-coupler input
Photo-coupler input
O/C output
O/C output