Concept2 MNV 4645 Manual page 141

Frost protection
If you are not going to use the appliance for a longer period of time or to place the appliance in places with low
temperatures, it is necessary to follow these steps:
1. Unplug the appliance from the mains.
2. Close and disconnect the water inlet hose from the water supply.
3. Dismantle the inlet hose and drain water from the hose and the dishwasher. To capture the water, you can use
a shallow container e.g. basin.
4. Reconnect the inlet hose to the dishwasher.
5. Remove the filter system and drain/wipe the remaining water (using for example a sponge).
Note:
• If there is ice and the dishwasher cannot be turned on, contact the service centre.
Tips for maintaining
• After each washing cycle, close the water supply and leave the dishwasher door slightly open to prevent
accumulation of moisture and odour.
• Before cleaning and maintenance, disconnect the power cord from the wall outlet.
• Do not use any coarse (e.g. steel wool, rough part of sponges) and sharp objects or aggressive cleaning agents,
they may scratch the surface of the appliance.
• For cleaning use a damp cloth dipped in water and detergent.
• If you intend not using the dishwasher for a longer period of time, run a washing program without dishware.
After each washing cycle, disconnect the power cord from the wall outlet and leave the dishwasher door slightly
open to prevent accumulation of moisture and odour. Leaving the door slightly open prolongs the life of the seal.
• Keep the appliance in an upright position when manipulating. If this is not possible, lay the appliance and
transport it on its back.
• Deposits on the seal are one of the sources of odours. Clean the seal to prevent that.
INSTALLATION OF THE APPLIANCE
Caution!
Risk of electric shock! Before installation, disconnect the power cord from the wall outlet. Otherwise there is a risk of
death or electric shock.
Built-in dishwashers installed as a free-standing appliance must be secured against overturning. They must be for
example screwed to the wall or placed under a worktop which is screwed to adjacent cabinets.
For safe operation the dishwasher must be installed by a qualified professional. Figures for the inflow and outflow
of water and electrical grid parameters must match with the figures listed in the technical specifications or in the
installation instructions.
• Defects caused by improper installation are not covered by the warranty.
• Installation is the responsibility of the customer not the manufacturer.
• The manufacturer bears no responsibility for damage caused to people, animals or property due to incorrect
installation.
• The dishwasher should be placed near the wall outlet, water supply and waste.
• There should be a space for inlet and drain hose on one side of the lower cabinet.
• Dimensions for mounting the appliance are shown in Pic. 12.
• If the dishwasher is installed in a corner of the lower cabinets, make sure there is a free space around the open
dishwasher door 50 mm (Pic. 13).
MNV 4645
EN CZ
141