Cisco Catalyst 3650 Command Reference Manual page 39

Layer 2/3 Commands
Command History
Release
Cisco IOS XE 3.3SE
Usage Guidelines
The undebug platform pm command is the same as the no debug platform pm command.
When you enable debugging on a stack, it is enabled only on the active switch. To enable debugging on the
standby switch , start a session from the active switch by using the session switch-number command in
privileged EXEC mode. Enter the debug command at the command-line prompt of the standby switch.
To enable debugging on the standby switch without first starting a session on the active switch, use the remote
command switch-number LINE command in privileged EXEC mode.
Examples This example shows how to display debug messages related to the creation and deletion of VLANs:
Switch# debug platform pm vlans
OL-32639-01
Layer 2/3 Command Reference, Cisco IOS XE Release 3.6E (Catalyst 3650 Switch)
debug platform pm
Modification
This command was introduced.
35