Cisco Catalyst 3650 Command Reference Manual page 51

Layer 2/3 Commands
Examples
This example shows how to set the learning method to learn the address on the physical port within the
EtherChannel:
Switch(config-if)# pagp learn-method physical-port
This example shows how to set the learning method to learn the address on the port channel within the
EtherChannel:
Switch(config-if)# pagp learn-method aggregation-port
You can verify your settings by entering the show running-config privileged EXEC command or the show
pagp channel-group-number internal privileged EXEC command.
Related Commands
Command
pagp port-priority
show pagp
OL-32639-01
Description
Selects a port over which all traffic through the EtherChannel is sent.
Displays Port Aggregation Protocol (PAgP) channel-group information.
Layer 2/3 Command Reference, Cisco IOS XE Release 3.6E (Catalyst 3650 Switch)
pagp learn-method
47