Switchport Mode - Cisco Catalyst 3650 Command Reference Manual

Layer 2/3 command reference, cisco ios xe release 3.6e
Hide thumbs Also See for Catalyst 3650:
Table of Contents

Advertisement

Layer 2/3 Commands

switchport mode

To configure the VLAN membership mode of a port, use the switchport mode command in interface
configuration mode. To reset the mode to the appropriate default for the device, use the no form of this
command.
switchport mode {access| dynamic | {auto| desirable}| trunk}
noswitchport mode {access| dynamic | {auto| desirable}| trunk}
Syntax Description
access
dynamic auto
dynamic desirable
trunk
Command Default
The default mode is dynamic auto.
Command Modes
Interface configuration
Command History
Release
Cisco IOS XE 3.3SE
Usage Guidelines
Note
Although visible in the CLI, the dot1q-tunnel keyword is not supported.
A configuration that uses the access,or trunk keywords takes effect only when you configure the port in the
appropriate mode by using the switchport mode command. The static-access and trunk configuration are
saved, but only one configuration is active at a time.
OL-32639-01
Sets the port to access mode (either static-access or dynamic-access depending on the
setting of the switchport access vlan interface configuration command). The port is
set to access unconditionally and operates as a nontrunking, single VLAN interface that
sends and receives nonencapsulated (non-tagged) frames. An access port can be assigned
to only one VLAN.
Sets the port trunking mode dynamic parameter to auto to specify that the interface
convert the link to a trunk link. This is the default switchport mode.
Sets the port trunking mode dynamic parameter to desirable to specify that the interface
actively attempt to convert the link to a trunk link.
Sets the port to trunk unconditionally. The port is a trunking VLAN Layer 2 interface.
The port sends and receives encapsulated (tagged) frames that identify the VLAN of
origination. A trunk is a point-to-point link between two switches or between a switch
and a router.
Layer 2/3 Command Reference, Cisco IOS XE Release 3.6E (Catalyst 3650 Switch)

switchport mode

Modification
This command was introduced.
75

Advertisement

Table of Contents
loading

Table of Contents