Mounting The Unit; Conditioning And Powering The Unit - Acuva Arrow 5 Owner's Product Manual

Installation Guide Cont'd

Mounting the Unit

1. Engage the spring-loaded mechanism of the mounting clips on the device
by hooking the clip onto the bottom edge of the DIN-rail and applying
slight pressure upwards.
2. As bottom portion engages, tilt the upper hook towards the DIN-rail.
3. Release the spring mechanism once the unit is mounted on the rail

Conditioning and Powering the Unit

1. Once the device is connected to the cold-water line, allow water to flow
through the system for 1-2 minutes until any bubbles are released from
the line. During this time, ensure all connections are tight and sealed.
2. Connect the DC power source or AC to DC power adapter to the device.
Hand-tighten the nut to the threaded jack to secure it.
3. If there is no water flow on powering up, the Acuva logo should glow
green for 30 seconds.
4. Turn on the faucet. The indicator LED will glow blue which indicates the
water purification is in progress. If the smart faucet is installed, its base
will glow blue as well.
5. Turn off the faucet and the device will automatically go into standby
mode
Advanced UV-LED Water Purification |
WARNING
Do not use a wrench or pliers to tighten the plug or power jack as
this may cause damage to the device.
acuvatech.com
Acuva's Arrow 5 UV-LED Water Purifier
O W N E R ' S P R O D U C T M A N U A L
Page 8