Troubleshooting; Standard Terms And Conditions - Acuva Arrow 5 Owner's Product Manual

Troubleshooting

Indicator LED State
Off (No water flow)
Off
(Water flow)
Red
Yellow Blinking
Blinking Red

Standard Terms and Conditions

The sale and use of all Acuva products is governed by the Acuva
Technologies Inc. Standard Terms and Conditions of Sale and Use (the
"Agreement"), a copy of which is available at www.acuvatech.com.
The Agreement contains important terms that, among other things, affect
Acuva's liability and your legal remedies against Acuva. Please read
the Agreement carefully as, by purchasing the Acuva product, you have
agreed to be bound by the entire Agreement including the limited warranty,
limitations of liability and methods of resolving disputes. In the event of
any inconsistency between this manual and the Agreement, the Agreement
shall prevail.
Advanced UV-LED Water Purification |
Fault Condition
No Fault
The unit is not powered
The flow direction is
reversed
The flow rate is too low
UV-LED fault
Low input voltage
Over-Temperature Fault
acuvatech.com
Acuva's Arrow 5 UV-LED Water Purifier
O W N E R ' S P R O D U C T M A N U A L
Comments to User
-
Verify that the unit is connected to power
and that the input voltage is within
specifications (11-16V).
Ensure the inlet and outlet tubes are
connected to the respective fittings
marked "IN" and "OUT" on the device.
The flow sensor inside the unit requires a
minimal water flow to activate the system
(approx. 0.3 Lpm). Ensure there is enough
water pressure in the line to reach this
flow.
Unplug and plug in the device's power
jack. If this fault persists, contact Acuva
for support.
Verify that the input voltage is above 11
volts.
Turn the device off and allow time to
for it to cool down and clear the error. If
the device repeatedly enters this state,
contact Acuva for support.
Page 10