More Operation Modes; Wireless Router Mode - TP-Link Archer VR400 User Manual

Chapter 4
5. Scroll down the page, enable IPv6, and configure the IPv6 parameters.
• Addressing Type: Consult your ISP for the addressing type (DHCPv6 or SLAAC).
SLAAC is the most commonly used addressing type.
• IPv6 Gateway: Keep the default setting as
Note: If your ISP has provided the IPv6 address, click
specified by ISP and enter the parameters provided by your ISP.
6. Click OK to make the settings effective. Now IPv6 service is available for your
network.
4. 5.

More Operation Modes

The modem router supports two more operation modes: Wireless Router mode and
3G/4G Router mode. You can change the mode according to your needs.
4. 5. 1.

Wireless Router Mode

If you already have a modem or your internet comes via an Ethernet jack on the wall, you
can set up the modem router as a regular wireless router to share the internet.
1. Find the WAN port (labeled as LAN4/WAN) on the modem router, and connect it
to your existing modem or the Ethernet jack on the wall. Then connect the power
adapter and turn on the modem router. If you connect an existing modem, reboot it
to get the modem router connected to the internet.
2. Connect your computer to the modem router. For details, refer to
Modem Router.
3. Visit http://tplinkmodem.net, and log in with your TP-Link ID or the password your
set for the router.
4. Go to Advanced
Save. The modem router will reboot.
> Operation Mode, select the
Set Up Internet Connections
Current Connection.
Advanced to reveal more settings. Check to use IPv6
Wireless Router
Connect Your
Mode, and click
17