More Operation Modes; Wireless Router Mode - TP-Link Archer VR400 User Manual

Chapter 4
4 Select your WAN Interface Name
(Edit) icon.
5 Scroll down the page, enable IPv6, and configure the IPv6 parameters.
Addressing Type:
SLAAC is the most commonly used addressing type.
IPv6 Gateway:
Note: If your ISP has provided the IPv6 address, click
IPv6 specified by ISP and enter the parameters provided by your ISP.
6 Click OK to make the settings effective. Now IPv6 service is available for your
network.
4 5

More Operation Modes

The modem router supports three operation modes: DSL Modem Router Mode, Wireless
Router mode, and 3G/4G Router Mode. The modem router uses the DSL Modem Router
Mode by default, and you can change the mode according to your needs.
4 5 1

Wireless Router Mode

If you already have a modem or your Internet comes via an Ethernet jack on the wall,
you can set up the modem router as a regular wireless router to share the Internet.
1 Find the WAN port (labeled as "WAN" or "LAN4/WAN") on the modem router, and
connect it to your existing modem or the Ethernet jack on the wall. Then connect
the power adapter and turn on the modem router. If you connect an existing
modem, reboot it to get the modem router connected to the Internet.
(Status
Consult your ISP for the addressing type, DHCPv6 or SLAAC.
Keep the default setting as
Set Up Internet Connections
should be Connected) and click the
Current Connection.
Advanced to reveal more settings. Check to use
14