Find The Phone's Ip Address; Reset To Factory Settings; Registering Phone; Manual Configuration - Grandstream Networks GXP1615 User Manual

NOTE: If you are using Power over Ethernet (PoE), you don't need to connect the AC adapter.
Make sure that the Ethernet cable and router or switch is Power over Ethernet (PoE) compliant.

Find the Phone's IP Address

Find out your Grandstream phone's IP Address.
Press the Middle navigation key.
Go to Status->Network Status and the IP address will be displayed on the display.

Reset to Factory Settings

Reset to factory settings
This step is not required for out-of-the-box phones, however, if the phone has been already used
then it is a must.
Press the Middle navigation key.
Go to System and navigate to the Factory Reset and press the Select button.
Confirm your action by pressing the Yes button.

Registering Phone

This section describes how to register the phone using Manual configuration or Auto
provisioning.
The following topics are covered:

Manual Configuration

Auto Provisioning
Manual Configuration
This section describes how to set UAD settings, create the PBXware Extension, and register the
phone.
The following topics are covered:
UAD settings
Creating Extension
Registering Phone
UAD Settings