Dhcp Server; Pbxware Version; Installation; Power Adapter - Grandstream Networks GXP1615 User Manual

Click the System Info link in the left hand navigation menu. The firmware version is shown
under the Software Version-Prog.

DHCP Server

Fully configured and operational DHCP server.

PBXware Version

PBXware version 5.3.6
In order to find out the PBXware version:
Log in to PBXware
Navigate to Settings: About.
On the top of About page, you may see a code similar to this one PBXware Edition: Business,
Release: 5.3.6 (041373f), Running: 1.4.24-gc-75ee203 where Release denotes the current
version of your PBXware.

Installation

This section describes how to install and connect the phone to the electrical power and data
network as well as how to apply factory settings.
The following topics are covered:

Power Adapter

Power over Ethernet (PoE)

Factory Settings
Power Adapter
Connect the Network and Power
Connect the DC plug on the power adapter to the DC port on the phone and connect the other
end of the power adapter into an electrical power outlet.
Connect the Ethernet cable between the Internet port on the phone and the network port on a
router or switch to access LAN.
NOTE: If you are using Power over Ethernet (PoE), you don't need to connect the AC adapter.
Make sure the Ethernet cable and router or switch is Power over Ethernet (PoE) compliant.
Power over Ethernet (PoE)
Connect the Network (only)
Using a regular Ethernet cable, your phone can be powered from a Power over Ethernet (PoE)
compliant router or switch.
Connect the Ethernet cable between the Internet port on the phone and an available port on
the in-line power router or switch.