Table of Contents
Advertisement
Mounting on a Vertical Surface
1. With a 3/16" (5 mm) drill bit, drill two holes approximately 2" (50 mm)
apart. Use a carpenter's level to ensure the holes will be level.
2. Drill two more holes 7-1/32" below the upper holes.
Mounting Temperature Station on a Vertical Surface
3. Insert the 1/4" x 1-1/2" lag screws through the flat washers, and through
the holes at the top of the shelter into the post.
Using an adjustable wrench or 7/16" wrench, tighten the lag screws.
4. Insert the 1/4" x 1-1/2" lag screws through the flat washers, and through
the holes at the bottom of the shelter into the post.
Using an adjustable wrench or 7/16" wrench, tighten the lag screws.
Lag
Screw
Flat
Washer
9
Advertisement
Table of Contents
