Set Id On The Temperature Station Using Dip Switches; Set The Console To Recognize The Signals - DAVIS Wireless Temperature Station Installation Manual

Note: The transmitter and receiver communicate with each other only when both are set to the same ID.
The factory default transmitter ID is '1'. Looking at the table below, you
can see that means the DIP switches are in the OFF position when each
transmitting station leaves the factory, whether it is an ISS, a wireless tem-
perature station, or another kind of station.
The ISS is included with every Wireless Vantage Pro2, so the console/
receiver is set to find the ISS on '1'. Set your temperature station to its
own ID number.
Use a ballpoint pen or paper clip to toggle DIP switches #1, 2, and 3. The
settings for transmitter IDs 1 – 8 are shown in the table below:
ID C
#1
(default)
#2
#3
#4
#5
#6
#7
#8
Use this table to ensure that each wireless transmitting station in your sys-
tem is broadcasting on its own transmitter ID.
Battery Holder
DIP Switches in Top-right Corner of SIM (Illustration has been enlarged for clarity)
Note: DIP Switches 1, 2 and 3 are for receiver ID settings. DIP Switch 4 is for TEST mode only.
Setting Console/Receiver(s) to Same ID
1. Put your console into Setup Mode — press and hold DONE and press
the DOWN arrow (-).
4
S 1 S
ODE WITCH WITCH
off
off
off
off
ON
ON
ON
ON
2 S 3
WITCH
off off
off ON
ON off
ON ON
off off
off ON
ON off
ON ON
ON
1 2 3 4
DIP Switches