Heinner HWM-5080VA++ Manual page 36

www.heinner.com
FAULT
Unsatisfactory washing
result.
Unsatisfactory
washing result.
As soon as the ma-
chine is loaded with
water, water dis-
charges.
No water appears
in the drum during
washing.
Laundries have
detergent residues
on them.
Grey spots appear
on the laundries.
POSSIBLE CAUSE
The contamination degree of
your laundries does not match
the programme you have
chosen.
Amount of detergent used
insufficient.
Laundries in excess of
maximum capacity put in
your machine.
Water being hard.
( Contaminated, lime water
etc.)
Laundries distributed in your
machine non- homogenously.
The end of water
discharging hose is too low
for the machine.
No fault. Water is in the
unseen part of the drum.
Non-dissolving particles of
some detergents may stick
to your laundries as white
spots.
The reason for such spots may
be oil, cream or ointment.
5Kg, 220-240V~50Hz, 800rpm
TROUBLE- SHOOTING
Select the programme appropriate for
the contamination degree of your
laundries. (See programme table)
Adjust the amount of detergent based
on the amount and contamination
degree of your laundries.
Load your machine with laundries,
amount of which will not exceed
maximum laundry capacity.
Adjust the amount of detergent based
on the instruction of detergent
manufacturer.
Spread your laundries in the
machine properly and
homogeneously.
Set the water discharging hose on
appropriate height.
Perform an Extra rinse by setting your
machine to "Rinsing" programme, or
clean the spots using a brush after
your laundries dry.
Apply the maximum amount of
detergent instructed by the detergent
manufacturer in the next washing
operation.
35