Database Modification Example - Datamax ST-3210 Operator's Manual

4.3.1

Database Modification Example

This section details the modification of an Operational Database
parameter. The following example increases the printing speed parameter
from 6 to 8 IPS on the ST-3210; however, using the same basic
procedure, any of the parameters can be changed regardless of the printer
model.
If on-line, press the PAUSE button to place the printer off-line.
Press and hold the F2 button until the On-Line Indicator is lit
(approximately six seconds) then release.
The printer will turn off the
On-Line Indicator and
print:
Press the F2 button three times (allow time for printing following
each button press), to arrive at the Print Speed parameter.
The printer will print:
Press the F1 button two times (again, allow time for printing
following each button press), to arrive at the 8 IPS setting.
The printer will print:
To save the changes and exit the mode, press and hold the F2 button
until the On-Line Indicator is lit (approximately six seconds) then
release.
The parameter changes can be confirmed by printing a Configuration
Ticket; see Section 3.5.1.
S-Class
STOCK ID
PRINT SPEED =
PARSER MODE =
TICKET WIDTH =
STOCK ID =
PRINT SPEED
PRINT SPEED
PRINT SPEED
PARSER MODE
TICKET WIDTH =
STOCK ID
= 5
6 IPS
AUTO
189 (48 MM)
5
= 8 IPS
= 7 IPS
= 6 IPS
= AUTO
189 (48 MM)
= 5
39