Interfacing - Datamax ST-3210 Operator's Manual

3.1

Interfacing

The printer can be connected to the host via the parallel, USB, or serial, The
printer will automatically connect to the first port that delivers valid data. Once
established, the printer's power must be cycled 'Off' and 'On' to change an
interface connection.
Serial Port
USB Port
Parallel Port
Power On/Off Switch
AC Power Connector
The Parallel Connection needs a Centronics
pin male connector for unidirectional (forward channel) communications,
or an IEEE 1284 Compliant cable for bi-directional communications
(forward and reverse channels). Also, for bi-directional communications
your host must have supporting software. See Section 5 for more
information.
The USB Connection needs a USB cable and is supported in
®
Windows 95 and greater operating systems. Depending upon the
operating system of your host computer, installation requirements may
differ slightly.
The Serial Connection needs a serial interface cable with specific pin-
outs for proper communications (part numbers and pin-outs are given,
below; contact your reseller to order). The interface supports RS-232C
communications via a DB-9 connector. Serial port settings are menu-
selectable and must match your host's serial port settings; see Section 4.
Part # 32-2300-01
8
Serial Port
USB Port
Parallel Port
AC Power Connector
Power On/Off Switch
®
IEEE 1284 cable with a 36-
Part # 32-2301-01
S-Class