Table of Contents
Advertisement
2
.
4
L
o
a
d
i
n
g
M
2
.
4
L
o
a
d
i
n
g
M
2
.
4
L
o
a
d
i
n
g
M
Load media into the printer as follows:
1. With the Cover open and the
Printhead Carrier Assembly raised,
remove the Media Hub and insert it
through the Roll Media (with the
labels spilling forward).
2. Place the Media Hub Flange (with its
smooth side toward the media) onto
the Media Hub.
3. Place the Media Hub, flange, and
media onto the Standoffs in the
printer.
4. Route the media through the printer,
as shown.
5. Slide the Media Guide and Media Hub Flange to the edge of the media.
6. Close the Printhead Carrier Assembly and press down until it locks into place.
7. Close the cover and press the
(If the printer does not correctly sense the top of each label, as denoted by the FAULT Light, it may be
necessary to perform the Calibration Procedure, Section 3.7.).
The printer is factory set to use 4-inch media (and ribbon, if thermal transfer equipped). When using
a different media width, refer to Chapter 4 for additional printer adjustments.
8
e
d
i
a
e
d
i
a
e
d
i
a
button several times to position the media and ensure proper tracking.
F2
Roll
Media
Printhead
Carrier
Chapter 2 – Printer Setup
Media Hub Flange
(smooth side toward media)
Media
Hub
Standoff
Printhead
Latch
Hide quick links:
Advertisement
Table of Contents
