Datamax Mark II E-4205e Operator's Manual page 62

Wifi Configuration Page (continued...)
Advanced Settings
Maximum Transmission
Rate
Use Fixed Rate for
Transmission
WLAN IP Settings
DHCP
DHCP Fallback
Retain DHCP Values
Persistent DHCP
Enable MAC Cloning
DHCP Client Name
DHCP Fixed Interval
Retransmission
DHCP Retransmit
Interval
DHCP Acquire Time Limit
DHCP Fallback IP
Address
DHCP Fallback Subnet
DHCP Fallback Gateway
Static BSS Address
Subnet Mask
Default Gateway
Primary DNS
Secondary DNS
56
Specifies the Module's maximum wireless transmission rate. Default is 2 Mbps.
Sets the 802.11 behavior for Ad Hoc mode. Default is 0.
Displays the current DHCP mode status.
This is the IP address to use with DHCP is enabled and a DHCP server cannot be found.
This instructs the wireless LAN to retain the latest DHCP provided IP address. This address
will be used in the event a DHCP server cannot be found on a subsequent restart.
This instructs the wireless LAN to copy the latest DHCP provided IP address to a static
address.
This instructs the wireless interface to assume the MAC address of the printer when
connecting to the wireless network.
Specifies the Module's DHCP client name. This should be different than the NetBIOS name
specified on the TCP/IP page.
Sets the DHCP retransmission mode to either Exponential (not checked) or Fixed interval
(checked). Default is not checked.
Sets the DHCP retransmission interval to use when "Enable DHCP Fixed Interval
Retransmission" is set to fixed. This is an integer with a range of 1-64. Default is 15.
Sets the number of seconds the DHCP should attempt to acquire an IP address before
using the fallback IP address, if wl-dhcp-fb is on. An integer with a range of 1-255. Default
is 150.
Displays the fallback IP address. Default is 192.168.10.1
Displays the fallback subnet mask. Default is 255.255.255.0
Sets the fallback gateway address. Default is 0.0.0.0.
Specifies the radio module's static IP address; up to four octets separated by a period. If
Enable DHCP is checked, this parameter is ignored. Default is 0.0.0.0.
Displays the radio module's subnet mask; up to four octets separated by a period.
Default is 255.255.255.0
Displays the Module's LAN IP address; up to four octets separated by a period.
Default is 192.168.0.1.
Displays the primary DNS server address for DNS lookups. If DHCP is enabled, the IP
address provided by the DHCP server is used.
Default is 0.0.0.0.
Displays the secondary DNS server address for DNS lookups when the primary DNS server
is unavailable.
Default is 0.0.0.0.
Appendix C – Ethernet Setup