Datamax Mark II E-4205e Operator's Manual page 52

+
Problem
Tear Mode is Another present
selected but the position has been
label stop position determined. Enabling
(present position) is the Present Sensor
not far enough causes the label stop
forward. position (present
position) to be
approximately 0.1"
behind the peel bar.
The Present Adjust
value is not correct.
Tear Mode is Another present
selected but the position has been
label stop position determined.
(present position) is
too far forward.
The Present Adjust
value is not correct.
The FAULT Indicator The label supply is
illuminates during empty
label alignment.
46
Possible Cause



~OR~

~OR~


Disable the Present Sensor.
Ensure the host computer is not providing a Present Distance
shorter than is required for the Tear Bar.
Use the Setup Menu to modify the Present Adjust value.
Ensure the host computer is not providing a Present Distance longer
than is required for the Tear Bar.
Use the Setup Menu to modify the Present Adjust value.
Load media.
Appendix B – Internal Menu
Solution
~OR~