Datamax Mark II E-4205e Operator's Manual page 43

To change Printer Setup, proceed as follows:
F1
(Press and hold during power-up until the Paused Light turns off)
Printer Setup Mode
F1 Prints the 'Printer Setup Menu List', see section B.2.1
F2
F2
F3 Prints the 'Test Label' for "test"
F1
Printer Setup Procedure
F1 Increments item's value
F2
F2
F3 Decrements item's value
F1
When adjusting CONT FORM LENGTH, LABEL WIDTH, or ALIGN LENGTH, momentarily pressing

will change the value by 1; and, holding either button down until the Fault light flashes will change
F2
the value by ten for each flash.
Appendix B – Internal Menu
(
)
Press and
Feeds one label for "test"
Release
(
Press and hold to advance to the desired menu
item by counting the number of Fault Light flashes
Saves the current values
F3
+
and resumes
Normal Mode
(Current Item and Value is printed)
(
Press and )
Selects the next menu item
Release
(
)
Press and
"Direct Select" menu item
Hold
Accepts the current
F3
+
values for "test"
)
(e.g., 9 Fault Light flashes = Baud Rate,
menu item #9; see Section B.2.2)
or
F1
37