Finishing The Installation; Attaching The Fan Blades - Savoy House 56-5075-5CN-11 Owner's Manual

8. FINISHING THE
INSTALLATION
Step 1. Tuck connections neatly into ceiling
outlet box.
Step 2. Slide the canopy up to hanger
bracket and place the key hole on the canopy
over the screw on the hanger bracket, turn
canopy until it locks in place at the narrow
section of the key holes. (Fig. 11)
Step 3. Align the circular hole on canopy with
the remaining hole on the hanger bracket,
secure by tightening the two set screws. (Fig.
11)
Note: Adjust the canopy screws as necessary
until the canopy and canopy cover are snug.
Warning: Make sure tab at bottom of hanger
bracket is properly seated in groove of
hanger ball before attaching canopy to
bracket. Failure to properly seat tab in groove
could cause damage to electrical wiring.
9. ATTACHING THE FAN
BLADES
Caution: Remove 5 rubber packing mounts
and discard before installation.
Step 1. Attach the blade to the blade bracket
using the screws and fiber washers as shown
in Figure 12. Start screw into bracket. Repeat
for the two remaining screws.
Step 2. Tighten each screw. Make sure the
blade is straight.
Step 3. Fasten blade assembly to motor
using the screws supplied. (Fig. 12)
Outlet box
Hanger
bracket
Screws
6
Canopy
Canopy cover
Figure 11
Screws
Fiber
washers
Blade bracket
Figure 12
Screws
Blade