Advertisement
EZ Roll Tonneau Installation Instructions
Assemble Clamps
Use the 5/16" Bolts and 5/16" Lock Washers to
assemble the Large and Small Outer Clamps to the
Inner Clamps. Create six (6) Clamp Assemblies.
With
Without
Utilitrack
Utilitrack
5/16"
System
Bolt
System
5/16"
Lock
Washer
Outer
Outer
Clamp
Clamp
Inner
Inner
Clamp
Clamp
Place Clamps
Place a Large Outer Clamp Assembly
on the Side Rail 6" behind the front pivot
mount. Place the a Small Outer Clamp As-
sembly 6" in front of the rear pivot mount.
Locate the center of the Side Rail and
place the remaining Large Outer Clamp
Assembly either 6" in front of this point or
6" behind it as needed for your vehicle.
Do Not Tighten the Clamps at this time.
Repeat on both sides of the vehicle.
Clamp positions may vary depending on
any bed accessories you may have.
Rev. D 0911
5/16"
Bolt
5/16"
Lock
Washer
Use position that works
best for your vehicle
Without
Utilitrack
System
Install Tonneau Cover Assembly
Standing in the bed if necessary, slide the ends of
the Front Rail on the Tonneau Cover Assembly into
the front Pivot Mounts on the Side Rails.
Front Rail
Front
Pivot
Mount
cover is on the vehicle.
Secure Tonneau Cover
Assembly
Unbuckle the Tie Down Straps. Press down fi rmly
on the end of the cover. Loosen the wing bolt and
slide the latch into the Side Rail. Tighten the wing
nut. Repeat on both sides of the vehicle.
With
Utilitrack
System
Unbuckle Tie
Down Straps
Tonneau Cover
Assembly
Front
Pivot
Mount
Both front latches must
remain engaged and the
wing bolts tight while the
Wing Nut
17175 pg. 3
Advertisement
