Download Print this page

Bestop 17175 Installation Instructions Manual

Ez roll tonneau for nissan titan crew cab

Advertisement

Quick Links

Installation Instructions
EZ Roll Tonneau
www.Bestop.com
- We're here to help! Visit our web site and click on
INSTALLATION TIME
1/2 Hour
TOOLS
1/2"
SKILL LEVEL
1 - Easy
Check and secure all clamps to bed frame as indicated in the installation instructions before
operating your vehicle.
Tonneau cover clamps must be securely attached prior to vehicle operation.
Secure retaining straps when cover is in open position.
Vehicle Application:
• Nissan Titan Crew Cab
"Ask a
Question". Click here for more
Wash vehicle to ensure that no dirt or abrasive materials are caught between the
truck's fi nish and the Tonneau Rail Frame.
5.5' Short Bed with or without Utilitrack System
2004 – 2007
Part Number: 17175
Truck Accessories by Bestop.

Advertisement

loading

Summary of Contents for Bestop 17175

  • Page 1 • Nissan Titan Crew Cab 5.5' Short Bed with or without Utilitrack System EZ Roll Tonneau 2004 – 2007 Part Number: 17175 www.Bestop.com - We’re here to help! Visit our web site and click on “Ask a Question”. Click here for more Truck Accessories by Bestop.
  • Page 2 Place Side Rails on Bed Locate the 2 side rails. Remove the protective tape Tonneau Cover Assembly, Part Number 471.16.17175, Qty - 1 on the bottom of each rail and place the rail on the bed on each side of the vehicle.
  • Page 3 Do Not Tighten the Clamps at this time. With Utilitrack Repeat on both sides of the vehicle. System Without Wing Nut Utilitrack Clamp positions may vary depending on System any bed accessories you may have. Unbuckle Tie Down Straps Rev. D 0911 17175 pg. 3...
  • Page 4 Washer is compressed. the vehicle. For proper function, it is best to leave a 1/8" gap between the Side Rail and Rear Rail. Side Rail Center Frame from Side to Side Tighten Front Clamps Rev. D 0911 17175 pg. 4...
  • Page 5 Make sure to keep the fabric tight across Side Rails. the bed to ensure a proper fi t. Fasten Hook and Loop Pull Latch Loosen Latch on Both Sides and Slide to Center Rev. D 0911 17175 pg. 5...
  • Page 6 Only trim the bottom, “eyelash”, part of the seal. cover. Make sure to adjust both sides to the same tension. 1/4" Hex Key Trim Seal even with Seal Bed Liner Trim only “Eyelash” Bed Liner Rev. D 0911 17175 pg. 6...
  • Page 7 Washing: The fabric should be washed often using soap, warm water and a soft bristle brush. Rinse with clear water to remove all traces of soap or use Bestop- recommended Bestop Cleaner and Bestop Protectant. Bestop Cleaner and Bestop Protectant are specially formulated to provide a total cleaning and protection system.