For jeep wrangler jk 2 door 2007; jeep wrangler jk 2 door 2008; jeep wrangler jk 2 door 2009; jeep wrangler jk 2 door 2010; jeep wrangler jk 2 door 2011; jeep wrangler jk 2 door 2012; jeep wrangler jk 2 door 2013; jeep wrangler jk 2 door 2014; jeep wrangl (11 pages)
Replace - A - Top Installation Instructions For: CJ5 ’76 - ’83 Part Number: 51117 Note: Please read this manual thoroughly before beginning the installation. After completing installation, keep this manual for further reference. Warning: This product is designed to enhance the appearance of the vehicle and to shield the occupants from ordinary weather conditions.
You are now ready to begin the installation process. Care and Maintenance of your Bestop Top Your top is made of the finest materials available. To keep it looking new and for the maximum possible wear, it will need periodic cleaning and maintenance.
Top Installation Step One Take the old bow covers off of the bows and slide on new ones. The long covers are for the rear bows and the short covers are for the front bows. Reinstall the bows on the vehicle. Step Two Check the windshield retainer placement.
Page 5
Step Two With a razor knife, cut the stitching on the old door covers and remove them from the frames. Step Three Start with the front of the door cover and locate the cut outs in the fabric for the door pins. Insert the door pins through the cut outs in the fabric and place the "First"...
Page 6
Leave attached to the Rear Bow. If you do not want the Rear Bow laying on the spare tire, you may remove the Clevis Pin and Keeper from Rear Bow and slide the Bow under the Front Bow in the Bow Mounting Bracket. Re-secure the Bow to the Bow Mounting Bracket with the Clevis Pin and Keeper. BESTOP HARD TOPS SOFT TOPS...